ACT Dryer Series Expert associated with this product. send mail Phone Call Online Interview Share: Send to a Friend Description Technical Specifications Product videos ACT Dryer Series ALUMINIUM TECHNOLOGIES DIRECT TO ENERGY SAVING FRIULAIR has increased it’s range of compressed air dryers with the introduction of the new ACT range (Aluminum Cooling Technologies). This high efficiently cooling module has a direct effect on reducing energy consumption and pressure drop. The main advantages are: Low pressure drop even with load variances; Constant pressure Dew Point with differing load conditions The components of ACT range, from refrigerant to materials of construction, have been selected with maximum respect for the environment and their ability to be recycled. Technical Details Control Panel Operation of the dryer is monitored by a digital thermometer in the control panel. The DMC20 electronic controller is fitted as standard to models ACT 900 – 1500 and as an option to models ACT 180 – 720. “Hot GAS” BY-PASS VALVE The precise and accurate hot gas by-pass valve, which prevents the formation of ice inside the evaporator at any load condition, is a recent development unavailable in the past. The valve is set during final test and no further adjustments are necessary. There is only one model of valve for each refrigerant used CONDENSATE DRAIN All models are fitted with a timed electronic drain. Discharge and pause times adjustable. A zero loss drain is available as an option. CONDENSER Generous sizing of the condenser ensures maximum performance of the refrigerate circuit and the ability to operate with changes in ambient condition. Access to the condenser for cleaning and maintenance is straight forward. It is mandatory to install a filter (with filtration grade at least 5 micron) on the dryer inlet side to prevent that rust, scale or other pollutants could clog the Alu-Dry Module and the condensate drain. ALU-DRY MODULE The air-to-air and air-to-refrigerant heat exchangers plus the demister type condensate separator are housed in an unique module. The counter flows of compressed air in the air-to-air heat exchanger ensure maximum heat transfer. The generous dimensions of the air-to-refrigerant heat exchanger plus the counter flow gas streams allow full and complete evaporation of the refrigerant (preventing liquid returning to the compressor). The high efficiency condensate separator is located within the heat exchanger module. No maintenance is required and the coalescing effect results in a high degree of moisture separation. The large capacity separator is designed to hold condensate also at high humidity in compressed inlet air. The large cross selection of flow channels within the heat exchanger module leads to low velocities and reduced. Technical Features Date refer to the following nominal condition: Ambient temperature of 25oC, the with inlet air at 7 barg and 35oC and 3oC pressure Dew Point (-22oC atmospheric pressure Dew Point). Max. Working condition: Ambient temperature 50oC, intel air temperature 70oC and inlet air pressure 14 barg (16 barg for ACT 3 to ACT 12). Upon request water-cooled version from model ACT 55 included (Max. water temperature 30oC). Friulair S.r.l reserves the right to modify, in any moment technical derails without notice.